Pet PP PE Crusher/Plastic Bottles Shredder / Plastic Recycling Machine

• Customization: Available
• After-sales Service: Online Support
• Warranty: 1 Year
• Model NO.: 500kg-tons
• Type: Hard Plastic Crusher
• Raw Material: PP
• Structure: Top Feed
• Knife Classification: Piece Knife Crusher
• Knife Roll: Solid Knife Roller
• Automation: Automatic
• Computerized: Non-Computerized
• Certification: CE
• Capacity: 1000kg/H
• Material of Knives: 60si2mn
• Material: 9crsi
• Knives: 10PCS
• Transport Package: Wooden Case
• Trademark: Shuliy
• Origin: China
• Production Capacity: 100PCS/Month

Product Description

If you are interested in this machine, contact Helen at any time.

Introduction:

Plastic crushers are mainly used to crush various thermoplastics and rubbers, such as plastic profiles,
pipes, rods, threads, films, and waste rubber products. The pellets can be directly used for extrusion and
injection molding.PET crusher/shredder

Ten blades, material is 9CrSi, wear-resiatance and high hardness


Operation attention of plastic shredder

1. The plastic pulverizer and power unit should be installed firmly. If the plastic crusher needs to be fixed
for a long time, it should be fixed on the cement foundation; if the plastic crusher needs to be flown, the
unit should be installed on the frame made of angle iron, and ensure that the power engine (diesel engine
or electric motor) and plastic The pulley grooves of the crusher are in the same rotation plane.

2. After the plastic crusher is installed, check the fastening of each fastener, and tighten it if it is loose. At
the same time, check whether the belt tightness is appropriate.

3. Before starting the plastic crusher, first turn the rotor by hand to check whether the operation of the claws,
hammers and the rotor is flexible and reliable, whether there is any collision in the crushing chamber, whether
the rotation direction of the rotor is consistent with the direction pointed by the machine, and whether the
power machine and plastic Whether the crusher is in good condition.

4. Do not replace the pulley casually, in case the rotating speed is too high to cause a crushing chamber, or the
rotating speed is too low to affect the working efficiency of the pulverizer.

5. After the plastic shredder is started, it should be kept idling for 2~3 minutes first, and there is no abnormal
phenomenon before feeding work.

6. Pay attention to the operation of the plastic crusher at any time during the work. First, the feeding should be
uniform to prevent the crushing chamber from being blocked; secondly, do not overload the work for a long time.
If it is found that there is vibration, noise, high temperature of the bearing and the body, and material spraying out,
it should be stopped immediately for inspection, and the work can be continued after troubleshooting.